-
- Latest Arduino CNC Shield Version 3.10.
- Coolant enable.
- Compact design.
- Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping )
- GRBL 0.9 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals).
- 4-Axis support (X, Y, Z, A-Can duplicate X, Y, Z or do a full 4th axis with custom firmware using pins D12 and D13).
- 2 x End stops for each axis (6 in total).
₹135.00 Excl. GST 18%
-
- 2 connections for 5V ‘hobby’ servos connected to the Arduino’s high-resolution dedicated timer.
- 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes.
- Can run motors on 4.5VDC to 25VDC.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution).
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, or interleaved stepping.
₹135.00 Excl. GST 18%
-
- Supply Voltage: 12V
- Reserved GCI like I2C and RS232
- Standard interfaces (as that of the extruder)
- Another 5A added to protect the component parts.
- 3 MOSFET’s are applied to the heater/ fan and thermistor circuit.
- Support 5 stepper drive board.
- An 11A fuse is added to the hotbed.
₹285.00 Excl. GST 18%